MÉDIC Construction 2027: changes in reimbursements
ConstruMD
Nov 18, 2026
All Posts
SHARE THIS POST
Published : November 5, 2026
A construction site toilet is not a perk offered when the project becomes large enough. It is a facility that must be available from the very first day of work. The Safety Code for Construction Work also specifies how many toilets are needed, how far they can be located, and in what condition they must be maintained.
These rules apply to places that meet the definition of a construction site, particularly during foundation work, erection, maintenance, renovation, repair, modification, or demolition carried out on the site itself.
This guide simply explains Quebec's requirements without turning every discomfort into a legal conclusion. The facts presented mainly come from articles 2.4.4 and 3.2.6 to 3.2.8.1 of the Safety Code for Construction Work.
Even if the work lasts a short time or involves only a few people, a toilet must be made available to workers from the first day. The threshold of 25 workers does not determine whether a toilet is necessary. It rather determines the minimum type of facility that must be available.
The rule can be summarized with four benchmarks: 1 day, 25 workers, 30 workers, and 150 metres. The facility must be present from the first day. Starting from 25 workers simultaneously, a flush toilet is required. There must be at least one toilet per group of 30 workers or less. Finally, access cannot normally be located more than 150 metres from the workplace.
When a site will never have more than 24 workers simultaneously, a chemical toilet can be made available to them. The important word is "can": the Code allows this type of facility, but a compliant flush toilet can obviously be provided.
A site with four people, ten people, or twenty-four people must therefore have at least one toilet. The fact that each worker has a vehicle or lives near the site does not automatically replace this facility.
If 25 workers or more are to occupy the site simultaneously, a flush toilet must be made available to them. This requirement must be planned according to the expected workforce, even if all workers have not yet arrived on site.
In other words, you should not wait for the twenty-fifth person to show up to start organizing the installation. The person in charge must look at the expected simultaneous occupancy of the site.
The Code requires one toilet per group of 30 workers or less. From 1 to 30 workers, at least one is needed. From 31 to 60, at least two are needed. From 61 to 90, at least three are needed. From 91 to 120, at least four are needed.
This calculation establishes the minimum number of facilities. It does not alone resolve issues of location, access, cleanliness, or actual capacity during breaks.
The toilet must be located no more than 150 metres, or 500 feet, from the workplace. It must also not be located more than four floors above or below this place.
This rule is particularly important on large sites, construction towers, and linear projects. A toilet present somewhere on the site is not necessarily compliant if a team has to travel an excessive distance to access it.
The obligation can be met when workers are genuinely authorized to use the sanitary facilities of an establishment located within the specified distance and floor limits. A gas station or a visible nearby business is not sufficient if no access is authorized or if the opening hours do not cover the work.
A toilet must be easily accessible and free of obstacles. For a position that cannot be left without relief, such as certain signalling functions, work organization must allow the worker to go to the toilet. The CNESST even gives this example in its guides: the access planned on paper must be usable in practice.
The user must be shielded from view, the weather, and falling objects. The facility should therefore not be placed directly under an area where materials can fall, nor be unusable due to a door that no longer closes.
The toilet must have natural or artificial lighting, be ventilated, and be heated to at least 20 °C. The Quebec winter does not suspend this requirement. A frozen cabin simply placed on the site does not meet the regulatory text.
The toilet must have a seat with a lid and toilet paper. Any cracked or damaged seat must be replaced immediately. The door, lighting, ventilation, and other necessary elements for use must remain functional.
The installation must be kept clean, sanitary, and in good condition. Its maintenance must eliminate the presence of vermin, rodents, and insects. The Code does not set a universal cleaning schedule applicable to all sites: the frequency must be sufficient to maintain the required state despite traffic and site conditions.
A chemical toilet may be suitable if the site will never exceed 24 workers simultaneously. It must still meet the requirements for access, privacy, heating, lighting, ventilation, paper, and cleanliness.
Each flush toilet must provide workers with a sink supplied with clean, tempered water. Soap or another cleaning substance is also required, as well as a means for drying hands: dryer, roll towels, or paper towels. If paper towels are used, a bin must be available for disposal.
When the sink water is not potable, a visible sign must indicate this. A hand sanitizer can be useful as a complement, but it does not replace the sink that the Code requires with a flush toilet.
The employer must provide workers with fountains or clean individual cups and a sufficient quantity of potable water. This obligation exists independently of the type of toilet installed.
In hot weather, water supply is also part of a comprehensive heat work plan. A cooler that is nearly empty at the start of the day does not guarantee a sufficient quantity for the entire shift.
When the water does not come from a municipal service, it must be tested at the start of the work and then at least every three months. This rule prevents assuming that a source, well, or reservoir automatically provides potable water.
Workers handling corrosive or toxic substances must have access to sinks or showers allowing them to wash with clean water, as well as paper towels or individual cloths. This requirement is aimed at work-related decontamination, not just general sanitary comfort.
Additional rules apply notably to certain underground work and certain exposures to asbestos, lead, mercury, beryllium, dust, or thermal constraints. It is necessary to consult the specific provisions of the Code according to the task and material involved.
Article 2.4.4 of the Code places toilets and their accessories among the general safety measures that fall under the responsibility of the general contractor on a site. In practice, the general contractor must therefore plan the installation, location, number, and maintenance of the necessary toilets for the site.
The employer remains responsible for providing workers with the potable water stipulated in article 3.2.6 and the washing means required when their work involves corrosive or toxic substances. Several employers present on the same site do not eliminate their respective obligations.
The health and safety representative can inspect the premises, identify problematic situations, and make recommendations to the committee, employer, health and safety coordinator, or general contractor. The CNESST precisely describes its functions, which also include assisting workers in exercising their rights.
Documenting this type of verification in a construction site safety meeting helps assign corrections and verify that they have indeed been made.
A toilet must be available from the first day. A chemical toilet is allowed since the workforce will not exceed 24 people, provided all other requirements are met.
At least one toilet is required. It can be chemical, but it must remain accessible, heated to 20°C, ventilated, lit, equipped, and clean.
At least one toilet is required according to the rule of one toilet per 30 workers. Since the planned workforce reaches 25 workers, a flush toilet must be made available to them, even if only 15 people are present during the first few days.
Two toilets are necessary according to the calculation per 30 workers. The responsible party must also apply the rule for sites with 25 or more workers and check the mandatory accessories for the flush toilet.
A toilet located only on the ground floor is more than four floors away from the work area. The location must be reviewed or an installation added to respect the vertical limit and make access truly usable.
False. The Code requires a toilet from the first day. A small workforce allows for the use of a chemical toilet; it does not eliminate the obligation.
Not automatically. Workers must be allowed to use the facility, which must be accessible during work and located within 150 meters and four floors.
False. The toilet must be heated to at least 20 °C. This requirement is part of the Code, just like lighting and ventilation.
False in the case of a flush toilet. The Code requires a sink supplied with clean, tempered water, with soap and a means of drying hands.
The worker can note the absence of a toilet, the distance, the number of people present, the temperature, the lack of paper, the obstruction, the absence of handwashing, or the lack of maintenance. A precise description helps distinguish a temporary inconvenience from a non-compliant installation.
The first reflex is generally to notify the foreman, employer, superintendent, health and safety coordinator, general contractor, or health and safety representative, depending on the site organization. The fix can be simple: immediate maintenance, adding supplies, relocation, or additional installation.
If the situation is not corrected, a person can consult the situations justifying a complaint to the CNESST. The right to refuse a task is based on the existence of reasonable grounds to believe in a danger and remains an analysis specific to each situation. The absence or poor condition of a toilet should not be presented as an automatic right of refusal without evaluating the context.
Before the teams arrive, the manager should confirm the maximum simultaneous workforce, the number and type of toilets, the distance from work areas, the floor difference, heating, lighting, ventilation, supplies, handwashing, drinking water, and maintenance frequency.
This check should be repeated when the workforce increases or teams move within the building. An installation compliant at the start of excavation may become too distant or insufficient as the project rises in height.
A toilet must be available from the first day, even on a small site. A chemical toilet may be suitable if the workforce will never exceed 24 workers. From 25 workers simultaneously, a flush toilet must be provided. The minimum number is one toilet per 30 workers or less.
The installation must be located no more than 150 meters and four floors from the workplace, be accessible, protect privacy, be heated to 20 °C, ventilated, lit, equipped, and maintained. The general contractor is responsible for the toilets and their accessories, while the employer must notably provide drinking water to their workers.
For specific decisions or a site with unusual constraints, the official text and the edition of the Code published by ASP Construction remain the references to check.
You might like
ConstruMD
Nov 18, 2026
ConstruMD
Nov 15, 2026
ConstruMD
Nov 11, 2026